Printable Template — Pelican Lid Controller Mount
Rectangular cutout + mounting holes + optional cable gland. Print at 100%; verify calibration.
Inputs (mm)
Center this on your lid reinforcement area; avoid ribs. Back the cut with an aluminum sub-plate if your controller clamps thin plastic.
What gets printed
| Cutout | 85 × 45 mm (R4) |
|---|---|
| Mount holes | 100 × 60 mm rectangle, Ø 4 mm |
| Bezel frame | 6 mm overlap around cut |
| Cable gland | None |
If your controller datasheet lists different centers/hole diameters, enter them and reprint.
Preview / Print Page
Calibration: 1″ square and 100 mm ruler must measure true on paper.